Projects

When the barrel of the rotary vacuum dryer is stacked with granular or powdery materials, when the angle between the inclined surface of the material stack and the bottom surface increases to a certai

A vacuum is a state of space without any matter. Sound cannot propagate under vacuum conditions because there is no propagation medium, but the propagation of electromagnetic waves is not affected by

After use, the residues in the drying container of the SZG double-cone rotary vacuum dryer should be cleaned, and the filter should be removed and cleaned frequently to keep the whole machine clean to

Turn on: Turn the drum motor button, start the power supply of the regulator, and control the speed to slowly increase from zero, generally six revolutions per minute;

The medium is indirectly heated by wet materials such as shell, end plate, stirring shaft, transmission device, rotary joint, support part and control system (steam heats the heat transfer oil, throug

Electromagnetic wave heating, automatic continuous production, resource saving, high quality, etc. are all unique characteristics of vacuum drying equipment. The following is a detailed summary of the

When the work is put into the vacuum dryer, it should be evacuated first and then heated up and heated. The purpose of this is to avoid the pressure generated by the expanding gas from bursting the te

The vacuum type disc continuous dryer is not targeted for the selection of materials. By drying low-temperature heat-sensitive materials, the dried materials are discharged from the discharge port at

The viscosity of the material in the double cone rotary vacuum dryer The viscosity of the material changes with its moisture content. The viscosity can make the material agglomerate into lumps and sti

Double cone rotary vacuum dryer is a new type of dryer integrating mixing and drying. The condenser, vacuum pump and dryer are matched to form a vacuum drying device. (If solvent recovery is not requi

The vacuum dryer can eliminate the phenomenon of surface hardening easily caused by normal pressure hot air drying. This is because the pressure difference between the material and the surface of the

Until now, spray drying is still considered a skill, to a certain extent. In the estimation and design process of the characteristics of the spray dryer, because the actual characteristics of the mate