During the working process of the fluidized bed dryer, dynamic loads will be generated. After insulation and shock absorption, some dynamic loads will also be sent to the base. Therefore, it is required that the fluidized bed dryer be set on the first floor and try to avoid fear. Vibrating machinery and equipment, instrument panels, etc.
The selection of the installation location should also take into account the installation location of supporting facilities and equipment (such as booster fans, dust removal equipment, electric heaters, centrifugal fans, feed shafts, pipes, etc.) to facilitate the operation and operation of the fluidized bed dryer. For maintenance, the fluidized bed dryer should be installed on a concrete foundation, and the basic installation surface should be fully aligned.
Adjustment after installation: Adjust the server after installation. First tighten the anchor screws, remove the support plate, connect the power supply, start, and test with a small amount of material. If the material has landslide movement, the problem is If it is uneven, it should be adjusted and seals should be added to the feet. Adjust it until the raw materials are distributed evenly on the circulating fluidized bed.
During operation, it is necessary to check whether the fluidized bed dryer and ancillary equipment (dehumidifying tissue, centrifugal fans, instruments, dashboards, etc.) comply with regulations. There should be no loose parts, all spare parts should be intact, there should be no leakage at the joints of valves and pipelines, the valves and switches should be functioning normally, the steam pipes should be smooth, and all equipment locations, utensils, tools, etc. that touch materials should be inspected. All are cleaned daily.
https://www.stardrying.com/
